Aercus WS3083 Installation Guide download pdf (Page 14)

WS3083

- 14 -

Outdoor Humidity

Press the MENU key eight times to select the OUTDOOR HUMIDITY section. Procedures and settings are

similar to Indoor Humidity above.

Outdoor Temperature

Press the MENU key nine times to select the OUTDOOR TEMPERATURE section, the OUTDOOR TEMPERATURE

section digits will start flashing. Press the UP or DOWN key to change the temperature display mode between

Temperature, Wind Chill and Dew Point.

Press the ENTER key to select the following modes, then press the UP or DOWN key to set the value:

 Temperature unit display C or F.

 Outdoor temperature high alarm (press ON/OFF to enable/disable). If the alarm is enabled, an

alarm symbol appears in the display.

 Outdoor temperature low alarm (press ON/OFF to enable/disable). If the alarm is enabled, an

alarm symbol appears in the display.

 Maximum temperature (since last reset). Resetting the maximum outdoor temperature value -

when both the outdoor temperature value and MAX icon are flashing, hold the ENTER key for 3s,

the maximum outdoor temperature value will be reset to the current reading.

 Minimum temperature (since last reset). Resetting the minimum outdoor temperature value -

when both the outdoor temperature value and MIN icon are flashing, hold the ENTER key for 3s, the

minimum outdoor temperature value will be reset to the current reading.

UV Index

Press the MENU key ten times to select the UV INDEX section, the UV INDEX section digits will start flashing.

Press the UP or DOWN key to change the UV high alarm (press ON/OFF to enable/disable). If the alarm is

enabled, an alarm symbol appears in the display.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Aercus WS3083 Installation Guide Page 14